Four Sealers, Four Jobs, and How to Tell Them Apart
Sealer gets picked last and fails first. The four in the Consolidated Aggregates line are not interchangeable, and the differences between them are specific enough to decide from.
Pro Seal for Matte Finishes and Color Work
Pro Seal is the water based acrylic that most decorative jobs end on. It has a 10 percent solids, low viscosity formula that penetrates clean unsealed concrete and dries clear with a natural matte finish.
Two properties set it apart from the rest of the line.
It mixes with liquid colors. The Liquid Color Pack is carried into the surface by Pro Seal for durable topical coloration, which makes this sealer part of the coloring system rather than just the protection over it.
It is breathable enough for green or uncured concrete and overlays. That matters on a schedule where the finish coat has to go on before the substrate has fully cured. It is also UV stable, non yellowing, and low VOC.
Pro Seal Supreme for Traffic and Sheen
Pro Seal Supreme is the water based, epoxy infused acrylic built for durability. The 20 percent solids, low viscosity formula gives strong penetration and adhesion on clean unsealed concrete.
It applies blue white and dries clear with a semi gloss finish. It is UV stable, non yellowing, and low VOC, which is what makes it viable on interior floors in occupied space.
Choose Supreme when the surface takes foot traffic, cleaning, and wear rather than sitting decorative. Interior floors, retail space, and entries are the common cases, and our page on smooth interior overlay work covers what goes under it.
Pro Seal 2500 for Solvent Based Exterior Work
Pro Seal 2500 is the solvent based option, formulated at 25 percent solids for a durable protective finish on decorative and conventional concrete.
The higher solids content enhances surface appearance while protecting against weathering and everyday wear. It is intended for applications where a solvent based sealer is preferred, and it carries a 700 VOC rating, which means the job has to be one where that is acceptable.
Exterior industrial surfaces, docks, ramps, and approaches are where it makes the most sense. Our page on loading dock repairs covers the repair side of that work.
Deck Seal for Waterproofing and Tint
Deck Seal is a different category rather than a fourth sheen option. It is a water based, tintable waterproofing sealer built for pool decks, patios, balconies, and walkways.
The 100 percent acrylic and urethane formulation creates a matte to semi gloss finish that stays flexible enough to withstand freeze and thaw conditions, which is the property that matters on an Ohio pool deck. It is low VOC, mildew resistant, UV stable, and non yellowing.
Tint is applied through a Deck Seal Tint Pack, which adds consistent decorative color while maintaining the protective performance of the sealer.
Reach for Deck Seal when waterproofing is part of the requirement rather than an incidental benefit.
What the Surface Underneath Has to Be
All four sealers specify clean concrete, and the reason is the same in every case.
A sealer bonds to whatever is on the surface. Release residue, dust, efflorescence, and previous coatings all become the thing the sealer adheres to, which produces peeling and cloudiness that get blamed on the product.
The International Concrete Repair Institute technical guideline on surface preparation covers preparation for sealers alongside coatings and overlays. Our guide to sealer selection covers the broader decision, including how exposure and traffic should factor in.
Why Ohio Contractors Buy Sealer From BonTon Supply
BonTon Supply distributes the Stone Edge line to Ohio contractors and tradesmen, and the staff applied these sealers on real jobs for over a decade before becoming a distributor. Sealer is the last product on a job and the first one a client notices when it goes wrong, which makes it worth a conversation rather than a guess. There are no minimum order quantities.
- Pro Seal matte finish for decorative work, liquid color, and green concrete
- Pro Seal Supreme semi gloss for interior traffic floors and higher durability
- Pro Seal 2500 solvent based for exterior and industrial exposure
- Deck Seal for pool decks, balconies, and surfaces needing waterproofing
- Deck Seal Tint Pack for consistent decorative color in the waterproofing layer
- Liquid Color Pack for base coloring, accenting, and antiquing through Pro Seal
- Smooth Coat Gray 50 lb for the interior surface going under Supreme
- Stamp Mix Gray 50 lb for the stamped surface going under Pro Seal
If you are looking at a finished surface and trying to decide which sealer belongs on it, the answer comes down to traffic, exposure, and whether the sealer is also carrying color. The BonTon Supply team can work through those three and get the right product on your order. Contact us to describe the surface.